So, I’ve figured out where my halyard shivs need to go for jib and storm jib, and also for fraction spinnakers.  However, there was no reinforcement in those areas so I had to add them before I get on with installing the shivs.  It was a bit cool today, so they didn’t cure hard enough to sand, but I’ll get that done tomorrow.

The bit I have wrapped at the mast head is a part I’m using for the mast head crane.  I put mold release on it so I can pop it off tomorrow and continue working on the crane.  I made the masthead shiv box today, but didn’t get a picture of it.  I’ll get some tomorrow. 

When I wasn’t tending to various bits of lamination I was finishing off my new pushpits which needed a bit of styling on the foot mounts, and primed one for painting before running out of primer.  Must remember to get some more of that in the morning.

Tomorrow tomorrow tomorrow…

-Ryan